Optics ready plates for Glock 48 MOS

This collection contains optic plates for the Glock 48 MOS. The plate goes into the factory optic cut of the slide and takes the red dot on top. Every plate is made for one footprint or a group of footprints, so you choose it by the footprint of your red dot.

Footprints for the Glock 48 MOS

• Holosun K-series: plates from Night Fision and 2BME.

Material

Night Fision makes its plates from steel. 2BME makes its plates from aluminium. An aluminium plate is lighter. A steel plate is heavier and robust.

Installation

Remove the cover plate from the optic cut, put the plate in and screw the red dot onto it. Use threadlocker on every screw. No milling and no gunsmith are needed.

All plates at a glance

Which red dot for which footprint

• Holosun K-series: the Holosun 407K and 507K, EPS Carry and SCS Carry. See Red dots with Holosun K-series footprint.

For all plates of this brand, see Optics ready plates for Glock models.

Frequently asked questions

Can I install an optic plate on my Glock 48 MOS at home?

Yes. You need no gunsmith and no milling.

1. Remove the cover plate from the optic cut.
2. Screw the optic plate into the cut.
3. Screw the red dot onto the plate.

Put a drop of threadlocker on every screw.

Which red dots will fit my Glock 48 MOS?

It depends on the plate you choose. For the Glock 48 MOS we have plates for the Holosun K-series footprint. Choose your red dot, find its footprint in the specifications and take the plate with the same footprint.